1. <label id="ckrvx"><s id="ckrvx"></s></label>

      1. <meter id="ckrvx"></meter>

          <menu id="ckrvx"><s id="ckrvx"><wbr id="ckrvx"></wbr></s></menu>

          歡迎訪問!詳細介紹各類輕質隔墻板的優勢和不足讓您只買對的不買貴的!

          金領域建材銷售有限公司

          —— 持續領航 品牌經營 ——

          全國服務熱線

          15515532955

          輕質隔墻板物理性能-GB/T23451-2009建筑輕質隔墻條板中文英文雙版

          來源:未知    發布時間:2021-04-03 15:05  點擊量:

          中文版輕質隔墻板物理性能介紹:
          5.5物理性能
          物理性能應符合表5的規定
          表5物理性能指標
          板厚90mm
          板原10
          抗沖擊性能
          經5次抗沖擊試驗后,板面無裂
          抗彎承載(板自重倍數)
          1,5
          抗壓強度/MPa
          面密度/(kg
          含水率/%
          干燥收縮
          吊推力
          0N置2(板面無超h.5m的數
          不應出可的裂且考面無
          A級
          水石之系數為>0o不板的化系
          夏熱冬
          斯條板不檢
          6試驗方法
          6.1試驗環境及
          試驗應在常溫
          下進不
          6.2外觀質量
          6.2.1量具
          鋼直尺,精度0,5m
          6.2.2測量方法
          對受測板,視距0.5m左右間測有無外露增強、貫通型(,泛霜;用鋼直尺量測板面裂健
          的長度、窩氣孔、缺校掉角數據,讀數至1m,用刻度放大慢量測裂健的寬度,并記錄塊陷數量
          6.3尺寸允許偏差
          6.3.1量具
          鋼卷尺精度1mm游標卡尺0~150mm;鋼直尺精度0.5mma內外卡錯、塞尺0~10mm靠尺2m
          6.3.2測量方法
          6.3.2.1長度
          量測三處
          一板邊兩處:靠近兩板邊100mm范國內,平行于該板邊
          板中一處:過兩板端中點,如圖2所示。

          Introduction to physical properties of lightweight partition board
          5.5 physical properties 
           
           physical properties shall comply with the provisions of table 5 
           
           physical property index of table 5 
           
           plate thickness 90mm 
           
           original 10 
           
           impact resistance 
           
           after five impact tests, the plate surface has no crack 
           
           bending capacity (plate weight multiple) 
           
           1, 5) compressive strength / MPa (compressive strength / 
          MPA) surface density / (kg 13; water content / / (kg 
           
           moisture content /% 
           
           drying shrinkage 
           
           lifting thrust 
           
           0n place 2 (plate surface has no super number of h.5m 
           
           there should be no cracks and no test surface has no grade a 
           
           grade a 
           
           grade of water stone coefficient is the coefficient of water 
          stone is the coefficient of water is the coefficient of no board 
          is the chemical system of no board chemical system of no 
          board summer hot summer hot winter is hot winter is hot 
          winter is the strip board is not inspected 
           
           strip is not inspected 
           
           6 test method 
           
           6.1 test environment and the test should be carried out at 
          room temperature, under normal temperature, the 
          appearance quality, the appearance quality, the appearance 
          quality, the appearance quality, the appearance quality, the 
          measuring tool, steel ruler, steel ruler, steel ruler, precision, 
          precision, precision, precision, precision, precision, precision, 
          precision, precision, precision, precision, precision 6.2.2 
          measurement method 
           
           for the plate under test, Measure whether there is exposed 
          reinforced, through type (, frosting) between the sight 
          distance of about 0.5m; use steel ruler to measure the length, 
          dimple hole, missing angle data of the plate surface crack 
          key, read to 1m, enlarge the scale slowly to measure the 
          width of the crack key, and record the number of blocks 
           
           6.3.1 measuring tool 
           
           steel tape precision 1mm vernier caliper 0 ~ 150mm; 
          Accuracy of steel ruler is 0.5mma, internal and external error, 
          feeler gauge is 0 ~ 10mm, guiding rule is 2m 
           
           6.3.2 measuring method 
           
           6.3.2.1 length 
           
           measuring three places 
           
           one plate edge two places: within the range of 100 mm near 
          two plate edges, parallel to the plate edge 
           
           one place in the plate: passing through the midpoint of two 
          plate ends, as shown in Figure 2
           
          微信二維碼 微信二維碼
          聯系我們

          電話:15515532955
          手機:15515532955
          Q Q:2424904545
          郵箱:2424904545@qq.com

          Copyright ? 2012-2020 金領域建材銷售有限公司< 版權所有 Powered by EyouCms

          備案號:豫ICP備15033061號

          被乡下老男人的粗大强行戳进

          1. <label id="ckrvx"><s id="ckrvx"></s></label>

              1. <meter id="ckrvx"></meter>

                  <menu id="ckrvx"><s id="ckrvx"><wbr id="ckrvx"></wbr></s></menu>